What’s
included with the heater?
1) The heater itself
2) Standard length heat duct (4 foot).
3)
Blower
4) Blower box
5)
Heat sensor in electrical box to go inside heat duct and metal cover.
6)
Romex conduit connectors (2)
7) High heat wire to go from sensor to blower via
electrical conduit.
8) Screws to put it all together.
9) 6 inch beauty ring and top collar for chimney pipe to go into.
What's not included with the heater - but you will probably need.
I am finding (1-24-12) that Lowe's and Home Depot in many areas have quit carrying 8 inch
pipe. You will need to look in your phone book for a "heating and ac supplier" to get the 8 inch pipe and flex ductwork.
A good heating and air shop can tell you where to purchase 8 inch products. 8 inch supplies are common in the heating and
cooling industry.
I do have almost all of the cold air return parts available. If you have a hard time finding
any items I can ship them out to you. Shipping will be actual shipping costs; I would ship with US mail. Contact me for more
information on cost and availability.
NOT INCLUDED:
1) 6 inch galv. pipe to use as chimney. Check local fire code to make sure
you get it tall enough from eve.
We have this available to ship via U.S. Mail if needed!
2) 6inch
metal rain cap
3) 10ft of ½ metal conduit for chimney braces/electric wire to run thru.
4) 2 tubes silicon to seal up your heater.
5) 1 roll new duct tape (small one)
6) Electrical wire to get power to the heater. (Must be wired to your local electrical code)
7) Some concrete
blocks to set the heater on to get it off the ground.
8) Optional prestress concrete pad.
9) Optional angle iron frame to set heater in.
10) 8 inch “starter” collar to attach to blower box for a “start” for your
cold air return.
11) 8 inch elbows to get the return line down and under your foundation
12) Either a 2ft or 5ft 8 inch galv. pipe to get you thru foundation.
13) 8 inch flexible duct work to run for your cold air
returns (comes in 25 ft boxes).
14) 8 inch tee if having more than one cold air return vent.
15) 4x12x8 floor boot for the cold air return Remember the cold air return must be no less than 8 inch!
16) Some kind of metal tape (plumbers tape) to go around the chimney pipe for the braces to bolt up with.
It bolts to the ends of the chimney braces.
These items are not expensive and won't add a real
large amount your to your overall cost of a heater($100.00 to $250.00)
Call Scott if you have questions about what you need to
hook up your heater.
